Hosted on MSN

Arduino Relay Basics - How It Works and How to Use It

Hi, I'm Bill. I'm a software developer with a passion for making and electronics. I do a lot of things and here is where I document my learning in order to be able to inspire other people to make ...
IEEE

Microfluidic Fluid Flow Design with Arduino Relay and Temperature Controller for Processor

Abstract: Considering microfluidic technology, this work has been innovated to consist of monitoring, temperature control and cooling sections. The work consists of peltier a module attached to the ...
CNX Software

ZigUNO – An Arduino UNO-sized Zigbee board that works with PTVO firmware

ZigUNO Zigbee development board comes with an Ebyte E18-MS1 module equipped with Texas Instruments SimpleLink CC2530 8051 Zigbee microcontroller and follows Arduino UNO form for Arduino Shield ...
CNX Software

T-Relay-8 – An ESP32 board with 8 relays

LilyGo T-Relay-8 is an ESP32 WiFi & BLE board equipped with eight 5V relays supporting up to 250V AC or 28V DC, as well as 16-pin GPIO header for expansion. The board offers a more compact solution ...
electronicsforu

DIY: Low-Cost IoT Solid-state Relay

Electromechanical relays are not reliable power switches. The electromagnet that they use needs to be energised till the plunger is at a specific position, thus consuming a lot of power. Most of the ...
elektormagazine

Raspberry Pi V4 no noise power supply for audio streamer:

What can be the best power supply ? One with isolated from the main 220v, battery power, linear regulated. The battery will be recharged when the Pi is not activated or when too low output voltage. An ...
GitHub

Collision between Sparkfun QWIIC Relay Library and QWIIC Serial Motor Library

I've discovered that if I use the two Sparkfun libraries for the QWIIC Relay, and the QWIIC Serial Motor Controller, that the two collide when defined as follows in a sketch: Yet, if I switch the ...